CUMMINS KILLER FROST PLUG PLATE - BD ('89-'02 5.9L CUMMINS)
The coolant pressure inside the engine block can reach 70+psi at high rpm before the thermostat fully opens. This will cause a corroded frost plug to leak. This rear frost plug plate by BD Diesel is able to seal the leak without the need to hammer out the old frost plug.
For rear coolant frost plug on 1989-2002 Dodge Ram Cummins 5.9L 2500/3500.
It's recommended to install the rear frost plug plate when the transmission is removed. The plate can be installed with the transmission in place, however the surface finish on the back of the motor is critical and must be checked prior to installation.
For rear coolant frost plug on 1989-2002 Dodge Ram Cummins 5.9L 2500/3500.
It's recommended to install the rear frost plug plate when the transmission is removed. The plate can be installed with the transmission in place, however the surface finish on the back of the motor is critical and must be checked prior to installation.
Write Your Own Review
Install and Tech Information
Videos
WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Featured Products
-
T-SHIRT - LONG LIVE THE DIESEL TRUCKAs low as $14.95 -
T-SHIRT - SURE, MY TRUCK'S A HYBRIDAs low as $16.95
-
T-SHIRT, GENO'S GARAGE, SHORT SLEEVE, GRAY (WICKING MATERIAL)As low as $16.95
-
T-SHIRT - O SAY CAN YOU "C" FLAG SHIRTAs low as $16.95
