IN-DASH GAUGE INSTALLATION BACK-PLATE - SINGLE ('94-'97)
Custom made in-dash installation kit for '94-'97 Dodge Ram trucks. The mount is used to install a gauge where the Overdrive Lockout/Fog Lamp switch bezel is located just to the left of the factory in-dash cup holder. If you have overdrive or fog lamps, this mount will not work.
NOTE: If this item is accompanied by a gauge order, there will be no charge for this item. Discount will be taken when order is shipped.
NOTE: This mount will work with 2" or 2-1/16" gauges.
NOTE: If this item is accompanied by a gauge order, there will be no charge for this item. Discount will be taken when order is shipped.
NOTE: This mount will work with 2" or 2-1/16" gauges.
Write Your Own Review
Install and Tech Information
'94-'97 In-Dash Gauge Back-Plate Instructions.pdfVideos
WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Featured Products
-
T-SHIRT - LONG LIVE THE DIESEL TRUCKAs low as $14.95 -
T-SHIRT - SURE, MY TRUCK'S A HYBRIDAs low as $16.95
-
T-SHIRT, GENO'S GARAGE, SHORT SLEEVE, GRAY (WICKING MATERIAL)As low as $16.95
-
T-SHIRT - O SAY CAN YOU "C" FLAG SHIRTAs low as $16.95
